How do u get a box to go into the skirts along foundry, while staying straight? i keep trying but it always comes out crooked and that's unnacceptable!
easiest way is to place two doors pushed up against the face of the box opposite where you want it to sink in, semi-sunken into the box with a wall at either side of the box next to the wall. Then quickly gab the box and release and it should go in just enough to be smooth with the flat part of the wall.
Never tried it but I suppose if you put a door on either face of the box and something on top to keep it from going up, it should work.
Thier way was the first. Someone else here found this way by accident. Can't remember who it was though. Not me. Also I think the forging 101 way is a bit more reliable.
The f101 methods could use some updating... The method in question is by far the least predictable and consistent. The door trick works best in my opinion, but I would strongly recommend limiting your use of GeoLocking because of its inherent unpredictability. You are just asking to waist hours and hours on it to get things just right. I use the technique sparingly and only when absolutely necessary. That is, until someone finds an easier way to do it! lol --dc