ok so i was geo-merging the outside set for my map and the first two were almost perfect but then this third one hated me and looked like this i have sender nodes set up as bracers in each corner and a reciever node in the middle two on each side just like the other ones but it came out different. i have done it more then once and they all looked about the same. please help
Well you should grab the object, wait a couple seconds and then save/quit without letting go. This will get your geomerges more precise. If it is still bumpy, just grab it again and save/quit. Repeat until it is even, or start over.
i dont let go when i save and quit but i have done it a couple times should i just keep trying until i get it how i want it?
Put a receiver nod on top of your said uneven double box, make sure the node is flat with the other double box. Place mancannons on the sides of the box pointing up so that the mancannons push up the double box when you grab it. Here's a diagram that might paint the picture a little better.
It's the same concept. /=Man Cannon [___]=Double Box /[___]\ Foundry's wall is behind my excuse for a diagram.
ok then thank you very much one quick question though i cant get a open double box to merge right how can i do that?