Unusual Equipment Respawn Issue

Discussion in 'Halo and Forge Discussion' started by BlackCloud, Aug 31, 2010.

  1. BlackCloud

    BlackCloud Forerunner
    Senior Member

    Messages:
    6
    Likes Received:
    0
    After I completely finished Forging a puzzle map I've been working on, I tested out all the puzzles and at first they seemed fine.

    But about 70% of the time, even though Radar Jammers are set to instant respawn, their respawn time is strangely eratic. Often, after throwing one, you'll get another and occasionally a third but after that there's a wait of about a minuite until the next one spawns.

    Interestingly, even after deleting all the equipment I was aware of, it still said that there was another Radar Jammer somewhere on the map, and try as I may I can't find it... If it's there at all.

    Even after glitching the map and flying around the dunes a few time, I can't find a thing.

    Any light that could be shed on this would be very much appreciated, thank you.
     
  2. Jex Yoyo

    Jex Yoyo POETRY, bitch.
    Senior Member

    Messages:
    3,872
    Likes Received:
    1
    If the Run Time Maximum is equal to the number on the map it wont instant respawn. If they are currently in use (like a radar that is jamming, lol) then they count until bout 30 seconds after they explode.
     
  3. BlackCloud

    BlackCloud Forerunner
    Senior Member

    Messages:
    6
    Likes Received:
    0
    Well, there's two placed on the map + the mysterious extra one and the runtime minimum/maximum is set to 4.
     
  4. BlackCloud

    BlackCloud Forerunner
    Senior Member

    Messages:
    6
    Likes Received:
    0
    Bumper jump bump.
     
  5. pyro

    pyro The Joker
    Senior Member

    Messages:
    3,703
    Likes Received:
    4
    Ignore the extra one. Raise the runtime minimum to the number on the map, then it should work regardless of the extra one on the map. Note that equipment still counts as on the map until it is used (weapons and equipment you are holding count towards the runtime minimum and maximum.)
     

Share This Page