Inter-Locking Problems

Discussion in 'Halo and Forge Discussion' started by magicmike5462, Aug 8, 2010.

  1. magicmike5462

    magicmike5462 Forerunner

    Messages:
    37
    Likes Received:
    0
    Hello, The other day I decided I would make my first serious map, so I read all the forging 201 and most of the forging 101 tutorials and started work on my map however I ran into problems straight away.
    I Know how important it is to have nice smooth floors to walk on so I started to interlock the first couple, and then I tested them... however as you may of geussed they were not flat and instead still bumpy. I put up all the guides I needed so I don't Know where it went wrong.
    If anyone could help me with this, it would help alot.
     
  2. Jex Yoyo

    Jex Yoyo POETRY, bitch.
    Senior Member

    Messages:
    3,872
    Likes Received:
    1
    If you use walls as your floors then it will be at least a little bumpy, and in reality its almost impossible to make it perfectly smooth. Its one of those things where you make it as close as possible then hope nobody notices it. Im assuming that you probably did it correct though because the objects also move themselves sometimes! D:<
     
  3. magicmike5462

    magicmike5462 Forerunner

    Messages:
    37
    Likes Received:
    0
    Thanks alot for you reply. It is only a little bumpy, I think I was trying to be to much of a prefectionist.
     
  4. Oo iRoNy oO

    Oo iRoNy oO Ancient
    Senior Member

    Messages:
    576
    Likes Received:
    0
    Ahh good times lolz. I used to be one as well. But then my friends convinced me that no one actually gave a **** lol. So now I just try and get it as close as possible.
     

Share This Page